How to replace the power supply of Anycubic Kobra Neo? The power supply of an FDM printer is the basic component of its electrical system, responsible for converting the incoming power into the proper voltage and current required to operate the FDM printer. FDM printers need it to ensure that the motors, heat beds, and other components get the power they need to operate optimally. When there is a problem or operational failure with an FDM power supply, we need to troubleshoot and resolve it, and replace the power supply if necessary. In this guide, we will mainly focus on the power supply problem of FDM printers, and provide the power supply replacement steps for Anycubic Kobra Neo.
Anycubic Kobra Neo Power Supply
- Power input: 110 V / 220 V AC, 50 / 60 Hz
- Rated power: 400 W
Troubleshooting Anycubic Kobra Neo power supply issues:
- Check power supply input. Check that the mains voltage is correct.
- Check power cord and connections. Check power cord for signs of damage, fraying, loose connections.
- Test output voltage. Compare the measured voltage with the rated voltage of the machine; if the deviation is too large, there may be a power supply failure.
How to Replace Power Supply of Anycubic Kobra Neo
Before replacing the power supply, please turn off the power switch and unplug the power cord. It is critical to prioritize safety during power supply replacement, so be prepared with appropriate safety equipment and handle with care.
- Tools: M2.5 hex key, M3.0 hex key, Phillips screwdriver, power supply
- For more questions, please contact our customer support staff for help.
Step 1: Use an M2.5 hex key to loosen the screws that secure the power supply. Use an M3.0 hex key to loosen the screws that secure the side of the power supply. Use an M2.5 hex key to loosen the screws on the cover of the power port.
Step 2: Use a Phillips screwdriver to loosen the screws securing the power supply wiring one by one and remove the power supply wiring.
Step 3: Replace the printer power supply. Use a Phillips screwdriver to loosen the screws one by one to remove the wiring locations. And according to the disassembly of the wiring order to install the power supply wiring back to the appropriate location and secure them.
Step 4: Use an M2.5 hex key to install and fix the power port cover. Use an M2.5 or M3.0 hex key to install and fix the power supply. Before starting up, please select the appropriate power supply gear according to the local voltage to avoid power supply damage.
Tutorial Video: How to Replace Power Supply of Anycubic Kobra Neo